ADM

Landing call module

The ADM is the interface between the landing panel and FST controller. The following land call modules are available:

ADM-S & ADM-D

The ADM-S and ADM-D land call modules form the interface between the landing call panel and FST control system. The ADM-S or ADM-D is connected to the FST via the LON bus. The ADM-S or ADM-D is typically installed on each floor.

Both modules are based on the same hardware and are available in the following software versions:

  • ADM-S: ADM Single for individual lifts
  • ADM-D: ADM Double for group lifts

The ADM-S or ADM-D are either installed and pre-wired in the landing call panel or delivered loose (to be installed in the shaft).

ADM-XF

The ADM-XF controls the connected landing call panels via separate ribbon cable. The ADM-XF is installed once in the control system and, from there, controls the buttons and direction indicators for up to 14 floors.
The ADM-XF is suitable only for individual lifts.

ADM-XK

The ADM-XK controls the connected landing call panels via the control cables connected to X1. The ADM-XK is installed once in the control system and, from there, controls the buttons and directional displays for up to 14 floors (2 buttons).
The ADM-XK is suitable only for individual lifts.

 
NEW_LIFT_blankgif